Difference between revisions of "LoliBot-Assembly"
(→1: Install headers on Lolin32-Lite) |
(→Check Parts In Kit) |
||
| Line 15: | Line 15: | ||
Your kit should contain the following items: | Your kit should contain the following items: | ||
| − | [[File:LoliBot-1-parts.jpg]] | + | [[File:LoliBot-1-parts.jpg|480px]] |
Your kit will also include an extra cable tie and a 3-way 90-degree header, which aren't shown in the picture above. | Your kit will also include an extra cable tie and a 3-way 90-degree header, which aren't shown in the picture above. | ||
Revision as of 09:41, 10 January 2018
Tools
Your own tools are not required for the Open Hardware Miniconf assembly session, but if you are able to bring any of the following then that would be great.
If you're flying, please bear in mind that sharp items like cutters or multimeter probes will need to be put into checked baggage not carry-on.
- Wire cutters (and wire strippers if you have them)
- Multimeter
- Soldering iron
- Solder
Check Parts In Kit
Your kit should contain the following items:
Your kit will also include an extra cable tie and a 3-way 90-degree header, which aren't shown in the picture above.
Please check over the items in your kit, and if you think you are missing something then let us know.
1: Install headers on Lolin32-Lite
The Lolin32-Lite development board is supplied without any headers fitted. 2 x 13-way pin headers are included in the package.
It's important to keep the headers straight while they are being soldered in place. To help with this, you can use the pair of 13-way sockets to cross-brace the pin headers as shown below. With the Lolin32-Lite placed on top, the pin headers will then be held straight so that you can solder them in place. The sockets can then be removed.
2: aoeu
aeua
